Clips Parts Holder For Airbrushing

Here is a new batch i made for my parts holder, with a twist! This was reinforced using good old masking tape.

Compared to the ones most modelers use

So why did i even bother changing the position of the clips? Here's why:

The marked area is where you hold them when taking them on and off your styro base. As you can see, the one on the right gives easier access with minimized risk of touching other parts.

Here is a common scenario using the traditional set up:

You can't afford to mount them straight for fear of touching the cleaned or painted parts, thus wasting a lot of space. With the slightly modified clip, it saves you space and gives great ease in mounting and pulling out the clips.